You may never need to replace another servo gear! These fast high quality Corona servos featuring ALL metal gears and ball bearings, are built for performance and extreme crash tolerance.

Fits all SkySeeker GT, Predator and most T-Hawk Servo Trays with one slight modification (see photo below). Note some T-Hawk versions used a special version with short standoff posts (see photo below) which must be replaced with the standard servo tray. The servo arms should also be trimmed as shown below for use with our standard servo tray.

A ready-to-install CS929MG servo assembly is also available for easy upgrading.

CS929MG Specifications:
Size	22.5X11.5X24.6mm (0.88"x0.45"x0.96")
Weight	12.5g
Operating Voltage	4.8V / 6.0V
Operating Current	200mA / 240mA
Operating Speed	0.12sec.60º / 0.10sec.60º
Stall Torque	2.0kg.cm / 2.2kg.cm
Dead Band	≤3uSec
Operating Travel	40º/one side pulse traveling 400us
Potentiometer	2 slider/Direct Drive
Ball bearing	MR85
Gears	All Metal
Connector wire length	215mm
Operating Temp Range	-20℃～+60℃