[ Home > ThunderBat XF ARF ]
ThunderBat XF ARF High Performance RC Electric ParkJet |
|
| High efficency 6.25x3.2 prop for 2050KV (high rpm) brushless motors. Predrilled 2.95mm center hole allows easy threading onto 3mm Brushless Motor shafts for a tight fit. Secure with end nuts. Black PolyCarbonate. |
|
|
| For 28mm diameter outrunner and inrunner brushless motors up to 22mm in length. Bracket may be cut to fit motor lengths up to 40mm. Molded PolyCarbonate black color. |
|
|
|
|
|
| EPO Foam wing/fuselage+tail set only |
|
|
|
|
|
|
|
|
| Includes 2pc set of clevis connector, horn, push rod, servo arm and servo screw. |
|
|
| Both sides (hooked and fuzzy) are included.
Two sets. |
|
|
|
|
|
|
|
|
|
|
|
| Features Reverse Switch and Adjustable Gain. For airplane or helicopter use. SPECS: Weight 11g Size 28x28x19mm |
|
|
| GWS DATASHEET (click on inset) IMPORTANT MOTOR OVERHEATING GUIDELINES FOR THUNDERBAT XF When using a 3 cell 11.1V LiPo battery, observe the following to avoid overheating which may damage the motor. Never run this motor continually for over 5 minutes when it's power exceeds 90W. Unless you have the ability to measure the power output and mark the corresponding throttle position, we recommend sliding the throttle trim all the way down. This usually will limit the full throttle stick output to about 90W. Never run the motor continually for over 10 seconds when it's power reaches 140W. This will correspond to full throttle stick with the throttle trim all the way up. Think of this as an "afterburner" mode to be enabled using the throttle trim. This will allow vertical climb and an extra boost in sport aerobatics. |
|
| Related Products ThunderBat XF KIT | ThunderBat XF ARF | ThunderBat XF PNP | ThunderBat XF RTF |
|
