[ Home > ThunderBat XF RTF ]

ThunderBat XF RTF 72Mhz Extreme Value Package
High Performance RC Electric ParkJet

INCLUDES:
Fully assembled ThunderBat XF Kit with decals and the following components installed:

Electric Motor - 2160KV GWS 2205/15T Outrunner Brushless
Propeller: 6.25" x 3.2" TENSHO 6332
ESC: 2-3 cell LiPo compatible 25A (GWSESC25A or equiv)
Servos: Sub Micro (8-9g) for ailerons and elevator
Gyro: Esky EK2-0704
Hardware: Motor Bracket,Servo Extension & Aileron Y-cable

ALSO INCLUDES:
Battery Options- LiPo 7.4V 1050mAh 15C Standard (recommended starter), LiPo 11.1V 1350mAh 12C Hop-Up , or both.
Battery Charger - Esky 2-3 cell LiPo Balance Charger EK2-0851
Radio: TENSHO SkyCommander 72Mhz 4CH Radio System

ThunderBat XF Product Details and Reviews

Browse the ThunderBat XF specific parts below for anything else you might like to include and take advantage of the FREE SHIPPING!

WARNING: Failure to follow the safety instructions and warnings provided with the lithium battery may result in fire and personal injury. By purchasing this battery, the buyer assumes all risks associated with lithium batteries.

Shipping Restriction:
This item will ship UPS Ground Service.


TENSHO 6332 HE Propeller High efficency 6.25x3.2 prop for 2050KV (high rpm) brushless motors. Predrilled 2.95mm center hole allows easy threading onto 3mm Brushless Motor shafts for a tight fit. Secure with end nuts. Black PolyCarbonate. TENSHO 6332 HE Propeller 60201		Motor Bracket For 28mm diameter outrunner and inrunner brushless motors up to 22mm in length. Bracket may be cut to fit motor lengths up to 40mm. Molded PolyCarbonate black color. Motor Bracket 60209


Nose Piece Nose Piece 60203		ThunderBat XF Foam AirFrame Set EPO Foam wing/fuselage+tail set only 60210


Turtle Deck Cover Turtle Deck Cover 60204		Servo Cover Set Servo Cover Set 60205


Push Rod Kit Includes 2pc set of clevis connector, horn, push rod, servo arm and servo screw. Push Rod Kit 60206		Velcro Battery Mount Strips 2pcs Both sides (hooked and fuzzy) are included. Two sets. Velcro Battery Mount Strips 2pcs 60207


Servo Extension Cable 15" 60261		Servo Y Cable 3" 60252


ThunderBat XF Decals 60211		Gyro Esky EG200A Features Reverse Switch and Adjustable Gain. For airplane or helicopter use. SPECS: Weight 11g Size 28x28x19mm Gyro Esky EG200A 20400


Motor Brushless OutRunner 2160KV GWS 2205/15T CNC GWBLM001A GWS DATASHEET (click on inset) IMPORTANT MOTOR OVERHEATING GUIDELINES FOR THUNDERBAT XF When using a 3 cell 11.1V LiPo battery, observe the following to avoid overheating which may damage the motor. Never run this motor continually for over 5 minutes when it's power exceeds 90W. Unless you have the ability to measure the power output and mark the corresponding throttle position, we recommend sliding the throttle trim all the way down. This usually will limit the full throttle stick output to about 90W. Never run the motor continually for over 10 seconds when it's power reaches 140W. This will correspond to full throttle stick with the throttle trim all the way up. Think of this as an "afterburner" mode to be enabled using the throttle trim. This will allow vertical climb and an extra boost in sport aerobatics. 20602